How You Can Color Fireplace Flames
If you enjoy sitting around your fireplace and watching colorful flames dance, you'll be happy to know you can color your own flames quite cheaply. Basically, there are three methods of coloring fireplace flames. You can soak the logs in an alcohol solution which contains certain chemicals. Or you can soak the logs in a water solution containing certain chemicals and then dry them. And finally, you can just throw certain chemicals into the flames. The various chemicals or salts required for certain colors of flames are as follows:
potassium sulphate ( 3 parts) and potassium nitrate (1 part) for violet flames
strontium chloride for red flames
calcium chloride for blue flames
magnesium sulphate (Epson Salts) for white flames
baronsalts (borax) for yellowish-green flames
copper sulphate (blue vitrol) for green flames
sodium chloride (table salt) for yellow flames
You may also treat pinecones, coarse sawdust or cork waste and throw them into the fireplace to color the fire. They are far easier to treat and take less time to dry. Here are two methods for treating bases such as course sawdust, pinecones and cork waste.
Best for sawdust - Dissolve the chemical in water. Stir in your base. When the solution is completely absorbed, spread the base out in a thin layer to dry.
Best for cork-based chips - Add 1 pint of liquid glue to 7 parts of water. Crush the chemical to a fine powder and add 1 pound of the powder to each gallon of glue-water. Put into the liquid as much of the sawdust, cork waste or pinecones that it will take, stirring and adding more base until all the liquid has been absorbed. Spread out on a rack to dry.
It is better to treat separate portions of your base with the solution of a single chemical than to treat the base in a single mixture of various chemicals. After drying the separately treated portions of sawdust or cork waste, you can then mix them together in order to achieve distinctly colored flames.
There is no fixed proportion of chemicals to be used to a given amount of water. As much of the powdered chemical should be mixed with water as will dissolve, until you have a saturated solution. The only exception is ordinary table salt (sodium chloride), in which case you should use 1/2 ounce of salt to each pint of water.
Coarse hardwood sawdust is better than pine or other softwood sawdust as a base. Cork waste also makes an excellent base.
Disclaimer & Product Information:
The text and documents contained in these reports were compiled
from a number of different sources, representing many different
viewpoints. For that reason, no claims of content accuracy or other
legal issues is made. Also, some of these reports were written
several years ago, so the information contained in them may be
slightly out of date.
No warranty is expressed or implied. These reports are sold and
distributed "as is". The reader is advised to seek legal counsel
before starting any business or implementing any ideas contained in
these documents should the reader need such advice.
Most of the information in these reports applies to people living
in the United States. Some of the information MAY be applicable to
other countries as well.
There is no copyright on the information in these reports.
Permission is granted to reprint, distribute by any means or even
resell these reports.